## REMOVE FRONT FOOTPAD
• REMOVE THE TWO FLATHEAD CAP SCREWS ON THE FOOTPAD CLOSE TO THE WHEEL WITH THE PROVIDED STAR KEY.

• FLIP BOARD OVER AND REMOVE THE SIX FLATHEAD CAP SCREWS ON THE UNDERSIDE OF THE FRONT BUMPER.
NOTE: THE HARDWARE IS HELD IN PLACE USING A THREAD LOCKING COMPOUND AND MAY REQUIRE SOME FORCE TO REMOVE. FLIP BOARD RIGHT-SIDE UP FOR NEXT STEP.

2

## LIFT FOOTPAD AND REMOVE BUMPER
• LIFT THE FOOTPAD FROM THE FRONT AND REST IT ON THE WHEEL TO REDUCE STRESS ON CABLES.

• REMOVE OLD FRONT BUMPER BY PULLING AWAY FROM THE BOARD.
NOTE: REMOVAL MIGHT REQUIRE SOME FORCE DUE TO SNUG FIT.

3

## BUMPER INSTALLATION
• INSTALL NEW FRONT BUMPER BY CAREFULLY LINING UP THE TABS AND SLOWLY PRESSING DIRECTLY TOWARDS THE BOARD.
NOTE: INSTALLATION MIGHT REQUIRE SOME FORCE DUE TO SNUG FIT.

4

## INSTALL FRONT FOOTPAD
• PLACE THE FRONT FOOTPAD DOWN LINING UP THE TWO HOLES. USE THE TWO SHORTER SCREWS TO ATTACH THE FOOTPAD.

• FLIP BOARD OVER AGAIN AND REPLACE THE SIX FLATHEAD CAP SCREWS ON THE UNDERSIDE OF THE FRONT BUMPER.
NOTE: IT IS RECOMMENDED TO START ALL SCREWS BEFORE SNUGGLY TIGHTENING THEM DOWN. THIS HOLDS TRUE FOR ANY REASSEMBLY YOU ARE GOING TO BE PERFORMING ON YOUR ONEWHEEL PINT.

---

## REMOVE BACK BUMPER

• REMOVE THE FOUR FLATHEAD CAP SCREWS ON THE UNDERSIDE OF THE BACK BUMPER.

NOTE: THE HARDWARE IS HELD IN PLACE USING A THREAD LOCKING COMPOUND AND MAY REQUIRE SOME FORCE TO REMOVE.

• REMOVE OLD BACK BUMPER BY PULLING AWAY FROM THE BOARD.

NOTE: REMOVAL MIGHT REQUIRE SOME FORCE DUE TO SNUG FIT.

## INSTALL BACK BUMPER

• INSTALL NEW BUMPER BY CAREFULLY LINING UP THE TABS AND SLOWLY PRESSING DIRECTLY TOWARD THE BOARD.

• REPLACE THE FOUR FLATHEAD CAP SCREWS ON THE UNDERSIDE OF THE BACK BUMPER.

NOTE: IT IS RECOMMENDED TO START ALL SCREWS BEFORE SNUGGLY TIGHTENING THEM DOWN. THIS HOLDS TRUE FOR ANY REASSEMBLY YOU ARE GOING TO BE PERFORMING ON YOUR PINT.